Mann Made Inc. Produces Highly Intricate Miniature Extrusions to the Most Exacting Tolerance

Solids, Semi-Hollows, Hollows & Tubing

Wall Thickness as Thin as .012"

Cross Sectional Areas as Low as .002"

Mating Sections, Snap Fits

Wave Guides, Heat Sinks, Micro Circuit Cases

1100, 2024, 3003, 6061, 6063, 6101, 6463 & 7075
Alloys Available

Certification Available

Tolerances as Close as .001 Depending Upon Shape

Special Services

Metallurgical and Engineering Assistance

Call us and gab about our miniature extrusion ideas. We love it.

Prototype Work

Small Dies are Cheaper to Make Than Large Dies, This is Reflected In Our Die Charge

Set Up is Easier on a Small Press, Our Charges Keep This in Mind

Fabricating, Sawing, Drilling, Taping, Milling, Sand Blasting, Punching, Tumbling

Anodizing Services Available

Limitations on 2024 & 7075

No hollow sections.
No semi-hollow sections.
No high ratio aspect sections.
Minimum wall thickness: 0.032".
Near uniform wall thickness required (2:1)
Maximum circumscribing circle diameter: 2 1/8".
Maximum cut length not to exceed 14' - 0" (168").
Minimum cut length for heavier sections desired in lengths: 4' - 0" (48").
Length formula for heavier sections (5.65 lbs (/) wt/ft of desired section) - 2' = max. length.

Limitations on Tubing

Minimum wall thickness: 0.015" (dependent upon O. D.)
Maximum inside diameter: 1.625"
Maximum outside diameter: 3.250" (for Alloys 6061 and 6063)
Maximum outside diameter: 2.250" (for Alloys 1100, 3003, 6101, 6463).
Maximum cut length: 20" - 0" (240") (dependent upon wt/ft).
Minimum cut length for lengths: 4" - 0" (48").
Length formula for heavier sections: (10.22 lbs (/) wt/ft of desired section) - 3' = max. length.

Limitations on High Ratio Aspect Profiles